A plumber in Atlanta would just do this to fix your leaking pipes
It’s friday night, a pipe has just sprung a leak, and you cannot find a plumber in atlanta. What do you do? You don’t have to panic. The first thing you need to do is turn off the water, either at the shut off valve near the pipe or at the main shutoff valve. This will buy you some time to figure out what to do next. You probably won’t get a plumber in to do the fix for a couple days and you may or may not be able to do it yourself. However, there are a few things you could do to get yourself through the next few days.
First, you have to gather some information on the leak. Is it a small hole or has the pipe split? Then, you can try some temporary fixes that will let you turn the water back on until a more permanent fix can be put in place. You can stick a pencil point into the hole and break it off. Wrap that in electrical tape or duct tape, whichever and smear some plumber’s putty on the tape. Let it sit for about a half hour before you turn the water back on. You could also try wrapping a piece of rubber around the pipe. You could use an old inner tube or a length of garden hose. Use a c-clamp and some small blocks of wood to clamp the rubber in place.
There are some more permanent steps you can take to fix the leak and these you can do yourself so you won’t have to find a plumber in Atlanta. You can use a pipe clamp specifically designed to fix a pipe leak. They have a rubber gasket inside the clamp and are designed to fit around a pipe. All you have to do is place the clamp around the pipe and tighten the screws. This will form a permanent seal. You can get them at someplace like Lowes or Home Depot. Another thing you could try is to use a braided/flexible metal tube with compression couples on each end. This can fix not only a small hole leak but also it can fix it if the pipe is split or even if the leak is in an elbow pipe. The tubes are avaialble in many sizes.
The way to install the metal tube is to first cut out the section of pipe where the leak is. Do this by placing the repair coupling against the broken section of pipe and mark the water pipe one inch from each end of the coupling. ONce you’ve cut out the pipe, slide the compression couplings into each end of the pipe and attach the repair coupling. Tighten the compression fittings. Now you turn the water back on to check for leaks.
One really great way to fix leaks is to have had copper pipes to begin with as these rarely have any leaks. However, galvanized pipes it is much more common to leak. And, since the pipe rusts from the inside out, you have no idea what kind of condition the pipe is in but you can be sure that if one starts to leak the others will soon.
Filed Under Diy Maintenance |
Tagged With atlanta, atlanta plumber, diy, leaking pipes, plumber, plumbing, quick fixes
Comments
Leave a Reply